市面上使用較多的成都升降機有兩種，剪叉式和導軌式的。剪叉式由于投入的時間較久有較大的市場占用率，而導軌式是近幾年才流行的一種貨物升降設備。There are two kinds of Chengdu lifts, which are used in the market, and the scissors and the guide rail. Shear fork type as a result of a longer time to invest a larger market occupancy rate, and the guide rail is only a few years before the popular cargo lifting equipment.

而如果客戶的使用頻率過高的話，則不建議使用剪叉式升降機，這是什么原因呢？And if the customer's use of the frequency is too high, then it is not recommended to use scissors fork lift, which is why?

由于剪叉式設備是通過自身的折疊上升和下降的，它每一次上升和下降都是各軸承之間一次磨損，長時間的使用，有時候就會磨斷軸承，而如果對此進行更換，則會造成平臺的不平行，從而產(chǎn)生更大的磨損。The scissor device is rising and falling through the folding itself, it each time the rise and fall of each bearing a wear, use for a long time, sometimes will wear off and bearing, if this replacement will cause the platform is not parallel, resulting in greater wear.

成都升降機廠家提醒，如果軸承磨損更換超過一半，則就會造成設備報廢。所以我們不建議使用頻率較高的位置使用這種類型的設備。Chengdu lift manufacturers to remind, if the bearing wear and replace more than half, it will result in equipment scrapped. So we do not recommend the use of a higher frequency position to use this type of equipment.